Curioustab

Home » Civil Engineering » Surveying

Subtense tacheometry is generally preferred to if ground is

flat
undulating
mountaineous
deserts.

Correct Answer: undulating

← Previous Question Next Question→

More Questions from Surveying

The conventional sign shown in below figure represents a
If L is the specified length of a tape, L1 its actual length and S the measured distance, then, the true distance is given by the formula,
You have to observe an included angle with better accuracy than what is achievable by a vernier, you will prefer the method of
Accidental or compensating errors of length L are proportional to
If a linear traverse follows a sharp curve round a large lake where it is difficult to have long legs, the accuracy of the traverse may be improved by
The operation of resection involves the following steps rough orientation of the plane table the three lines form a triangle of error drawing lines back through the three control points select a point in the triangle of error such that each ray is equally rotated either clockwise or anti clockwise the points obtained by three rays is the correct location. The correct sequence is
Pick up the correct statement from the following
Check lines (or proof lines) in Chain Surveying, are essentially required
The distance between terminal points computed from a subsidiary traverse run between them, is generally known, as
A sewer is laid from a manhole A to a manhole B, 250 m away along a gradient of 1 in 125. If the reduced level of the invert at A is 205.75 m and the height of the boning rod is 3 m, the reduced level of the sight rail at B, is

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion