Discussion
Home ‣ Technical Drawing ‣ Auxiliary Views Comments
- Question
When adding dimensions to an auxiliary view it will be necessary to use the ________ tool.
Options- A. Linear dimension
- B. Aligned dimension
- C. Baseline dimension
- D. Angle dimension
- Correct Answer
- Aligned dimension
- 1. A secondary auxiliary view is a projection off of the ________.
Options- A. Front view
- B. Top view
- C. Primary auxiliary view
- D. None of the above Discuss
- 2. This type of solid is formed by sweeping a shape along a linear path:
Options- A. Planar solid
- B. Revolved solid
- C. Warped solid
- D. Extruded solid Discuss
- 3. When using the descriptive geometry method to create an auxiliary view the drafter should ________.
Options- A. rotate the snap grid to the same angle of the inclined plane
- B. offset the right vertical line of the front view
- C. rotate the top line of the front view 45 degrees
- D. offset the top line of the front view 2 inches Discuss
- 4. The offset distance for the width (front to back) distance of the auxiliary view is the same distance of the ________ in the top view.
Options- A. Width
- B. height
- C. length
- D. none of the above Discuss
- 5. The lines used to create the auxiliary view should appear as ________ in the finished view.
Options- A. Object lines
- B. Construction lines
- C. Reference lines
- D. Construction lines Discuss
- 6. In this type of auxiliary view, a break line is used to indicate the imaginary break in the views:
Options- A. Primary
- B. Secondary
- C. Revolved
- D. Partial Discuss
- 7. Circular shapes appear in this fashion when viewed at an angle other than 90 degrees:
Options- A. Circular
- B. Elliptical
- C. Lengthened
- D. Angular Discuss
- 8. Approximately this much of the cost of product development and manufacture is determined at the design stage:
Options- A. 40-50%
- B. 60-75%
- C. 70-80%
- D. 75-85% Discuss
- 9. This process recognizes the inherent interrelationships between design and manufacturing:
Options- A. Design for manufacture
- B. Design for manufacture and assembly
- C. Design for concurrent engineering
- D. Design for assembly Discuss
- 10. This is a solid shape that fits inside the mold and forms a hole in a cooled cast metal or molten plastic object:
Options- A. Core
- B. Cavity
- C. Prototype
- D. Hole mold Discuss
Auxiliary Views problems
Search Results
Correct Answer: Primary auxiliary view
Correct Answer: Extruded solid
Correct Answer: rotate the snap grid to the same angle of the inclined plane
Correct Answer: Width
Correct Answer: Object lines
Correct Answer: Partial
Correct Answer: Elliptical
Correct Answer: 70-80%
Correct Answer: Design for manufacture and assembly
Correct Answer: Core
Comments
There are no comments.More in Technical Drawing:
Programming
Copyright ©CuriousTab. All rights reserved.