Discussion
Home ‣ Technical Drawing ‣ Multiview Drawing Comments
- Question
In multi-view drawing it is common practice to include three views, the front, the top and the right side. If no dimensions are required on the right side view the drafter can ________.
Options- A. leave the view as is
- B. eliminate the view
- C. use the left view instead
- D. none of the above
- Correct Answer
- eliminate the view
- 1. The section view drawing in which one fourth of an object has been marked for removal is known as a ________ section.
Options- A. full
- B. half
- C. quarter
- D. none of the above Discuss
- 2. When only a small section of an interior area needs to be revealed the drafter can use a ________ section.
Options- A. half
- B. quarter
- C. full
- D. broken out Discuss
- 3. By using a ________ section of a cylindrical mechanical part the drafter should be able to show only one view of the part.
Options- A. half
- B. whole
- C. revolved
- D. broken out Discuss
- 4. This type of section is limited by a break line:
Options- A. Removed section
- B. Revolved section
- C. Broken-out section
- D. Half section Discuss
- 5. A ________ section allows the drafter to create a Cutting Plane line which is not in a straight line across the part.
Options- A. Offset
- B. half
- C. whole
- D. broken out Discuss
- 6. The type of line that projects from an object for the express purpose of locating a dimension is a ________ line.
Options- A. visible
- B. hidden
- C. extension
- D. dimension Discuss
- 7. In developing a multi-view drawing the drafter can use a ________ line to help locate the top and right side views.
Options- A. object
- B. hidden
- C. dimension
- D. miter Discuss
- 8. A full scale technical drawing will have a scale factor of ________.
Options- A. 1:1
- B. 1:2
- C. 2:1
- D. 1:4 Discuss
- 9. Center lines are used to locate or represent the centers of ________.
Options- A. arcs
- B. circles
- C. hidden round features
- D. all of the above Discuss
- 10. If a designer is developing a plan for a project in which the entire part is made out of ¾" thick plywood and he only wants to use one view, he should use the ________ view.
Options- A. front
- B. top
- C. right
- D. back Discuss
Multiview Drawing problems
Search Results
Correct Answer: half
Correct Answer: broken out
Correct Answer: revolved
Correct Answer: Broken-out section
Correct Answer: Offset
Correct Answer: extension
Correct Answer: miter
Correct Answer: 1:1
Correct Answer: all of the above
Correct Answer: front
Comments
There are no comments.More in Technical Drawing:
Programming
Copyright ©CuriousTab. All rights reserved.