logo

CuriousTab

CuriousTab

Discussion


Home Technical Drawing Sectional Views Comments

  • Question
  • When only a small section of an interior area needs to be revealed the drafter can use a ________ section.


  • Options
  • A. half
  • B. quarter
  • C. full
  • D. broken out

  • Correct Answer
  • broken out 


  • Sectional Views problems


    Search Results


    • 1. By using a ________ section of a cylindrical mechanical part the drafter should be able to show only one view of the part.

    • Options
    • A. half
    • B. whole
    • C. revolved
    • D. broken out
    • Discuss
    • 2. This type of section is limited by a break line:

    • Options
    • A. Removed section
    • B. Revolved section
    • C. Broken-out section
    • D. Half section
    • Discuss
    • 3. A ________ section allows the drafter to create a Cutting Plane line which is not in a straight line across the part.

    • Options
    • A. Offset
    • B. half
    • C. whole
    • D. broken out
    • Discuss
    • 4. These breaks are used to shorten the view of an object:

    • Options
    • A. Section breaks
    • B. Aligned breaks
    • C. Conventional breaks
    • D. Full breaks
    • Discuss
    • 5. In this type of section, one quarter of the object is removed:

    • Options
    • A. Revolved section
    • B. Removed section
    • C. Quarter section
    • D. Half section
    • Discuss
    • 6. The section view drawing in which one fourth of an object has been marked for removal is known as a ________ section.

    • Options
    • A. full
    • B. half
    • C. quarter
    • D. none of the above
    • Discuss
    • 7. In multi-view drawing it is common practice to include three views, the front, the top and the right side. If no dimensions are required on the right side view the drafter can ________.

    • Options
    • A. leave the view as is
    • B. eliminate the view
    • C. use the left view instead
    • D. none of the above
    • Discuss
    • 8. The type of line that projects from an object for the express purpose of locating a dimension is a ________ line.

    • Options
    • A. visible
    • B. hidden
    • C. extension
    • D. dimension
    • Discuss
    • 9. In developing a multi-view drawing the drafter can use a ________ line to help locate the top and right side views.

    • Options
    • A. object
    • B. hidden
    • C. dimension
    • D. miter
    • Discuss
    • 10. A full scale technical drawing will have a scale factor of ________.

    • Options
    • A. 1:1
    • B. 1:2
    • C. 2:1
    • D. 1:4
    • Discuss


    Comments

    There are no comments.

Enter a new Comment