Curioustab

Home » Digital Electronics » Shift Registers

What is meant by parallel load of a shift register?

All FFs are preset with data.
Each FF is loaded with data, one at a time.

Correct Answer: All FFs are preset with data.

← Previous Question Next Question→

More Questions from Shift Registers

With a 200 kHz clock frequency, eight bits can be serially entered into a shift register in ________.
What does the output enable do on the 74395A chip?
If an 8-bit ring counter has an initial state 10111110, what is the state after the fourth clock pulse?
What is a transceiver circuit?
In a parallel in/parallel out shift register, D0 = 1, D1 = 1, D2 = 1, and D3 = 0. After three clock pulses, the data outputs are ________.
An 8-bit serial in/serial out shift register is used with a clock frequency of 150 kHz. What is the time delay between the serial input and the Q3 output?
A sequence of equally spaced timing pulses may be easily generated by which type of counter circuit?
When an 8-bit serial in/serial out shift register is used for a 20 µs time delay, the clock frequency is ________.
Another way to connect devices to a shared data bus is to use a ________.
A 74HC195 4-bit parallel access shift register can be used for ________.

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion