Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Digital Electronics
»
Multivibrators and 555 Timer
The pulse width out of a one-shot multivibrator increases when the:
supply voltage increases
timing resistor decreases
UTP decreases
timing capacitance increases
Correct Answer:
supply voltage increases
← Previous Question
Next Question→
More Questions from
Multivibrators and 555 Timer
What is another name for a bistable multivibrator?
A 0.3-µF capacitor has an initial charge of 2.7 V. If it is discharged through a 10-kΩ resistor for 6.5 ms, how much voltage will be left across the capacitor?
The bistable multivibrator is an R-C flip-flop.
A single Schmitt trigger inverter is all that is needed to build a simple astable multivibrator.
In the 74121, which is nonretriggerable, any triggers that come in before the end of the timing cycle are ignored.
When extremely critical timing is required, a quartz crystal can be used.
A comparator simply outputs a HIGH or LOW based on a comparison of the voltage levels at its input.
When the 74123, a retriggerable monostable multivibrator device, ends its timing cycle it must be started all over again.
Timing accuracy of more than eight significant digits can be easily achieved by using quartz crystals.
The 74S124 TTL chip is a voltage-controlled oscillator that will generate a specific frequency at Vout.
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments