Curioustab

Home » Digital Electronics » Memory and Storage

The time from the beginning of a read cycle to the end of tACS or tAA is referred to as:

access time
data hold
read cycle time
write enable time

Correct Answer: access time

← Previous Question Next Question→

More Questions from Memory and Storage

Which of the following best describes static memory devices?
To which pin on the RAM chip does the address decoder connect in order to signal which memory chip is being accessed?
For the given circuit, what is the bit length of the output data word?
What part of a Flash memory architecture manages all chip functions?
Which of the following is not a flash memory mode or operation?
Advantage(s) of an EEPROM over an EPROM is/are:
The condition occurring when two or more devices try to write data to a bus simultaneously is called ________.
Refer to the given figures (a) and (b). A logic analyzer is used to check the circuit in figure (a) and displays the waveforms shown in figure (b). The actual analyzer display shows all four data outputs, Q0-Q3. The analyzer's cursor is placed at position X and all four of the data output lines show a LOW level output. What is wrong, if anything, with the circuit?
Typically, how often is DRAM refreshed?
Suppose that a certain semiconductor memory chip has a capacity of 8K × 8. How many bytes could be stored in this device?

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion