Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Digital Electronics
»
Flip-Flops
Four positive edge-triggered D flip-flops are used to store a 4-bit binary number as shown below. Determine if the circuit is functioning properly, and if not, what might be wrong.
The circuit is functioning properly.
Q2 is incorrect; the flip-flop is probably bad.
The input to flip-flop 3 (D2) is probably wrong; check the source of D2.
A bad connection probably exists between FF-3 and FF-4, causing FF-3 not to reset.
Correct Answer:
Q2 is incorrect; the flip-flop is probably bad.
← Previous Question
Next Question→
More Questions from
Flip-Flops
The symbols on this flip-flop device indicate ________.
To completely load and then unload an 8-bit register requires how many clock pulses?
A 555 operating as a monostable multivibrator has a C1 = 100 µF. Determine R1 for a pulse width of 500 ms.
As a general rule for stable flip-flop triggering, the clock pulse rise and fall times must be:
Propagation delay time, tPLH, is measured from the ________.
The output pulse width of a 555 monostable circuit with R1 = 4.7 kΩ and C1 = 47 µF is ________.
What does the triangle on the clock input of a J-K flip-flop mean?
What is another name for a one-shot?
An invalid condition in the operation of an active-HIGH input S-R latch occurs when ________.
The timing network that sets the output frequency of a 555 astable circuit contains ________.
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments