Curioustab

Home » Digital Electronics » Flip-Flops

The asynchronous inputs are normally labeled and , and are normally active- inputs.

PRE, CLR, LOW
ON, OFF, HIGH
START, STOP, LOW
SET, RESET, HIGH

Correct Answer: PRE, CLR, LOW

← Previous Question Next Question→

More Questions from Flip-Flops

What type of multivibrator is a latch?
A retriggerable one-shot has a pulse width of 10 ms; 3 ms after being triggered, another trigger pulse is applied. The resulting output pulse will be ________ mS.
The point(s) on this timing diagram where the Q output of a D latch will be HIGH is/are ________.
A gated S-R flip-flop goes into the CLEAR condition when ________.
The signal used to identify edge-triggered flip-flops is ________.
A gated D latch does not have ________.
A positive edge-triggered flip-flop will accept inputs only when the clock ________.
A gated S-R flip-flop is in the hold condition whenever ________.
The postponed symbol () on the output of a flip-flop identifies it as being ________.
When the output of the NOR gate S-R flip-flop is in the HOLD state (no change), the inputs are ________.

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion