Home » Civil Engineering » UPSC Civil Service Exam Questions

The plastic modulus of a section is 5 x 10-4m3. Its shape factor is 1.2 and the plastic moment capacity is 120 kNm. What is the value of the yield stress of the material?

100 N/mm2
200 N/mm2
240 N/mm2
288 N/mm2

Correct Answer: 240 N/mm2

← Previous Question Next Question→

More Questions from UPSC Civil Service Exam Questions

The figure refers to a channel section of uniform thickness of 1 cm used as a beam with the cross-sectional dimensions shown in cm units. If the Moment of Inertia of channel Ixx be equal to 246 cm4 and C be the shear centre, then the value of e in cm is equal to
Consider the following statements : 1. An ascending gradient of 1 in 100 meets an ascending gradient of 1 in 120 to form a Valley curve. 2. A falling gradient of 1 in 25 meets a falling gradient of 1 in 50 to form a summit curve. 3. The length of summit curve is determined on the basis of head light sight distance. Which one of the statements given above is/are correct?
Activated sludge is the
The given figure shows gradually varied flow in an open channel with a beak in bed slope. Types of water surface profiles occurring from left to right are
For total reaction time of 2.5 seconds, coefficient of friction 0.35, design speed 80 km/h, what is the stopping sight distance on a highway?
Which are the critical activities of the bar chart shown above?
What is the use of a station pointer?
Consider the following methods of preservation of timber : 1. Dipping 2. Brushing or spraying 3. Pressure impregnation The correct sequence in decreasing order of the effectiveness of these methods of preservation is
To generate 10, 000 hp under a head of 81 m while working at a speed of 500 rpirt, the turbine of choice would be
In a PERT network, the activity durations are given as to (optimistic), tp (pessimistic) and tm (most likely time). What is the variance of is activity?

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion