Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Civil Engineering
»
Theory of Structures
Maximum shear stress theory for the failure of a material at the elastic limit, is known
Guest's or Trecas' theory
St. Venant's theory
Rankine's theory
Haig's theory
Von Mises's theory.
Correct Answer:
Guest's or Trecas' theory
← Previous Question
Next Question→
More Questions from
Theory of Structures
If D and d are external and internal diameters of a circular shaft respectively, its polar moment of inertia, is
For determining the force in the member AB of the truss shown in the given figure by method of sections, the section is made to pass through AB, AD and ED and the moments are taken about
If a concrete column 200 x 200 mm in cross-section is reinforced with four steel bars of 1200 mm2 total cross-sectional area. Calculate the safe load for the column if permissible stress in concrete is 5 N/mm2 and Es is 15 Ec
Gradually applied static loads do not change with time their
If M, I, R, E, F, and Y are the bending moment, moment of inertia, radius of curvature, modulus of elasticity stress and the depth of the neutral axis at section, then
A shaft subjected to a bending moment M and a torque T, experiences
The force in EC of the truss shown in the given figure, is
A steel bar 20 mm in diameter simply-supported at its ends over a total span of 40 cm carries a load at its centre. If the maximum stress induced in the bar is limited to N/mm2, the bending strain energy stored in the bar, is
m1 and m2 are the members of two individual simple trusses of a compound truss. The compound truss will be rigid and determinate if
If the normal stresses due to longitudinal and transverse loads on a bar are σ1 and σ2 respectively, the tangential component of the stress on an inclined plane through θ°, the longitudinal load is
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments