If D and d are external and internal diameters of a circular shaft respectively, its polar moment of inertia, is

More Questions from Theory of Structures

• For determining the force in the member AB of the truss shown in the given figure by method of sections, the section is made to pass through AB, AD and ED and the moments are taken about
• If a concrete column 200 x 200 mm in cross-section is reinforced with four steel bars of 1200 mm2 total cross-sectional area. Calculate the safe load for the column if permissible stress in concrete is 5 N/mm2 and Es is 15 Ec
• Gradually applied static loads do not change with time their
• If M, I, R, E, F, and Y are the bending moment, moment of inertia, radius of curvature, modulus of elasticity stress and the depth of the neutral axis at section, then
• A shaft subjected to a bending moment M and a torque T, experiences
• The force in EC of the truss shown in the given figure, is
• A steel bar 20 mm in diameter simply-supported at its ends over a total span of 40 cm carries a load at its centre. If the maximum stress induced in the bar is limited to N/mm2, the bending strain energy stored in the bar, is
• m1 and m2 are the members of two individual simple trusses of a compound truss. The compound truss will be rigid and determinate if
• If the normal stresses due to longitudinal and transverse loads on a bar are σ1 and σ2 respectively, the tangential component of the stress on an inclined plane through θ°, the longitudinal load is
• A compound truss may be formed by connecting two simple rigid frames, by

Discussion & Comments