Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Civil Engineering
»
Theory of Structures
If a concrete column 200 x 200 mm in cross-section is reinforced with four steel bars of 1200 mm2 total cross-sectional area. Calculate the safe load for the column if permissible stress in concrete is 5 N/mm2 and Es is 15 Ec
264 MN
274 MN
284 MN
294 MN
None of these.
Correct Answer:
284 MN
← Previous Question
Next Question→
More Questions from
Theory of Structures
Gradually applied static loads do not change with time their
If M, I, R, E, F, and Y are the bending moment, moment of inertia, radius of curvature, modulus of elasticity stress and the depth of the neutral axis at section, then
A shaft subjected to a bending moment M and a torque T, experiences
The force in EC of the truss shown in the given figure, is
A steel bar 20 mm in diameter simply-supported at its ends over a total span of 40 cm carries a load at its centre. If the maximum stress induced in the bar is limited to N/mm2, the bending strain energy stored in the bar, is
m1 and m2 are the members of two individual simple trusses of a compound truss. The compound truss will be rigid and determinate if
If the normal stresses due to longitudinal and transverse loads on a bar are σ1 and σ2 respectively, the tangential component of the stress on an inclined plane through θ°, the longitudinal load is
A compound truss may be formed by connecting two simple rigid frames, by
The radius of gyration of a rectangular section (depth D, width B) from a centroidal axis parallel to the width is
The ratio of the section modulus of a square section of side B and that of a circular section of diameter D, is
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments