Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Civil Engineering
»
Theory of Structures
The force in EC of the truss shown in the given figure, is
zero
5t tension
5t compression
4t tension
None of these.
Correct Answer:
5t compression
← Previous Question
Next Question→
More Questions from
Theory of Structures
A steel bar 20 mm in diameter simply-supported at its ends over a total span of 40 cm carries a load at its centre. If the maximum stress induced in the bar is limited to N/mm2, the bending strain energy stored in the bar, is
m1 and m2 are the members of two individual simple trusses of a compound truss. The compound truss will be rigid and determinate if
If the normal stresses due to longitudinal and transverse loads on a bar are σ1 and σ2 respectively, the tangential component of the stress on an inclined plane through θ°, the longitudinal load is
A compound truss may be formed by connecting two simple rigid frames, by
The radius of gyration of a rectangular section (depth D, width B) from a centroidal axis parallel to the width is
The ratio of the section modulus of a square section of side B and that of a circular section of diameter D, is
In case of a simply supported I-section beam of span L and loaded with a central load W, the length of elasto-plastic zone of the plastic hinge, is
For a strongest rectangular beam cut from a circular log, the ratio of the width and depth, is
To determine the force in BD of the truss shown in the given figure a section is passed through BD, CD and CE, and the moments are taken about
In case of principal axes of a section
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments