Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Civil Engineering
»
Theory of Structures
Maximum principal stress theory for the failure of a material at elastic point, is known
Guest's or Trecas' theory
St. Venant's theory
Rankine's theory
Haig's theory
Von Mises's theory.
Correct Answer:
Rankine's theory
← Previous Question
Next Question→
More Questions from
Theory of Structures
A steel plate d x b is sandwiched rigidly between two timber joists each D x B/2 in section. The moment of resistance of the beam for the same maximum permissible stress σ in timber and steel will be (where Young's modulus of steel is m times that of the timber).
A masonry dam (density = 20, 000 N/m3) 6 m high, one metre wide at the top and 4 m wide at the base, has vertical water face. The minimum stress at the base of the dam when the reservoir is full, will be
Slenderness ratio of a long column, is
The moment of inertia of a rectangular section of width B and depth D about an axis passing through C.G. and parallel to its width is
If normal stresses due to longitudinal and transverse loads on a bar are σ1 and σ2 respectively, the normal component of the stress on an inclined plane θ° to the longitudinal load, is
The forces acting on the bar as shown in the given figure introduce
The ratio of the stresses produced by a suddenly applied load and by a gradually applied load on a bar, is
is the equation of Euler's crippling load if
Maximum shear stress theory for the failure of a material at the elastic limit, is known
If D and d are external and internal diameters of a circular shaft respectively, its polar moment of inertia, is
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments