Curioustab

Home » Civil Engineering » Theory of Structures

The eccentricity (e) of a hollow circular column, external diameter 25 cm, internal diameter 15 cm for an eccentric load 100 t for non-development of tension, is

2.75 cm
3.00 cm
3.50 cm
4.25 cm
5.0 cm

Correct Answer: 4.25 cm

← Previous Question Next Question→

More Questions from Theory of Structures

Maximum principal stress theory for the failure of a material at elastic point, is known
A steel plate d x b is sandwiched rigidly between two timber joists each D x B/2 in section. The moment of resistance of the beam for the same maximum permissible stress σ in timber and steel will be (where Young's modulus of steel is m times that of the timber).
A masonry dam (density = 20, 000 N/m3) 6 m high, one metre wide at the top and 4 m wide at the base, has vertical water face. The minimum stress at the base of the dam when the reservoir is full, will be
Slenderness ratio of a long column, is
The moment of inertia of a rectangular section of width B and depth D about an axis passing through C.G. and parallel to its width is
If normal stresses due to longitudinal and transverse loads on a bar are σ1 and σ2 respectively, the normal component of the stress on an inclined plane θ° to the longitudinal load, is
The forces acting on the bar as shown in the given figure introduce
The ratio of the stresses produced by a suddenly applied load and by a gradually applied load on a bar, is
is the equation of Euler's crippling load if
Maximum shear stress theory for the failure of a material at the elastic limit, is known

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion