Curioustab

Home » Civil Engineering » Structural Design Specifications

When bending occurs about both axes of the member, the value of fbe in the formula |> 1 is taken

higher value
lower value
sum of the two
difference of the two.

Correct Answer: sum of the two

← Previous Question Next Question→

More Questions from Structural Design Specifications

M 30 grade concrete means, its compressive strength of 15-cm cube, is 30 N/mm2 after
The characteristic strength of concrete is the strength of material if its test result is not less than
Creep of concrete is assumed proportional to the stress if the stress does not exceed .......of the characteristic compressive strength
For design purpose, the moment at the support where two unequal spans or spans not equally loaded meet, is
The ratio of the effective lengths of two columns, one effectively held in position at one end and partially restrained at the other end, and the other effectively held in position at one end and free at the other end, is
The pitch of transverse reinforcement of a column is taken as
The maximum pitch of rivets for compression and tension members should not exceed
As per IS : 1982, the permissible axial tension in rolled I-beams and channels, is
Minimum diameter of the lateral ties should not be less than
The tolerances for the form work of columns and beams range from

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion