Minimum diameter of the lateral ties should not be less than

More Questions from Structural Design Specifications

• The tolerances for the form work of columns and beams range from
• The maximum spacing of shear reinforcement should not exceed 0.75 d subject to a minimum of
• Pick up the correct statement applicable to cased columns.
• The ratio of the effective length to the least radius of gyration of a tie member of a roof truss, which gets subjected to reversal of stress shall not exceed
• The individual part of the structures is subjected to a load test for 24 hours by applying a load equal to full dead load of the structure plus
• If the ratio of effective span to overall depth of a simply supported beam is less than 1, the lever arm is
• The maximum bending moment in a purlin of length L when subjected to a distributed load ω, is assumed
• The average 28 days compressive strength of at least three 15 cm concrete cubes prepared with available water as compared to the average strength of three similer concrete cubes prepared with distilled water, should be at least
• If the ends of the compression flanges of simply supported girders are fully restrained against lateral bending, the effective length is taken as
• If fbt and fs are the numerical values of bending tension and shear stresses, the equivalent stress fe, is

Discussion & Comments