Curioustab

Home » Civil Engineering » Structural Design Specifications

The reinforcing bars in beams are not bundled in contact if the diameter of the bars, exceeds

12 mm
20 mm
35 mm
30 mm
36 mm

Correct Answer: 36 mm

← Previous Question Next Question→

More Questions from Structural Design Specifications

The ratio of minimum compressive strength on 15 cm cubes prepared with the concrete of M 20 grade and M 40 grade, at 7 days should be at least
Moist curing of the exposed surfaces of concrete is done at least for
In compression members, the lap length of a bar should not be less than
The grade of concrete generally not used in the reinforced concrete, is
The effective and actual lengths of a cantilever are same if continuous at the support,
For design of a column the eccentricity of loading shall be taken as the distance from the assumed point of application of the load to the centroid of the column, subject to a minimum of
The gap between web plates and flange plates for fillet welds should not be more than
Dispersion of load through the flange to web is considered as dispersed uniformly at an angle θ° is
If the ratio of effective span to overall depth of a simply supported beam is equal or greater than 1 but less than or equal to 2, the lever arm, is
In the formula a + bk for the calculation of the net effective section of single angles in tension connected by one leg only, the value of k, is

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion