Curioustab

Home » Civil Engineering » Structural Design Specifications

The maximum spacing of shear reinforcement should not exceed 0.75 d subject to a minimum of

300 mm
350 mm
400 mm
450 mm
500 mm

Correct Answer: 450 mm

← Previous Question Next Question→

More Questions from Structural Design Specifications

Pick up the correct statement applicable to cased columns.
The ratio of the effective length to the least radius of gyration of a tie member of a roof truss, which gets subjected to reversal of stress shall not exceed
The individual part of the structures is subjected to a load test for 24 hours by applying a load equal to full dead load of the structure plus
If the ratio of effective span to overall depth of a simply supported beam is less than 1, the lever arm is
The maximum bending moment in a purlin of length L when subjected to a distributed load ω, is assumed
The average 28 days compressive strength of at least three 15 cm concrete cubes prepared with available water as compared to the average strength of three similer concrete cubes prepared with distilled water, should be at least
If the ends of the compression flanges of simply supported girders are fully restrained against lateral bending, the effective length is taken as
If fbt and fs are the numerical values of bending tension and shear stresses, the equivalent stress fe, is
Minimum thickness of steel work directly exposed to weather but not accessible for cleaning and repainting, the thickness should be not less than
If b is the width of a beam, x is the spacing of the stirrup and fc is the characteristic strength of stirrups, the minimum cross sectional area of stirrup legs, should be equal or greater than

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion