The grade of concrete generally not used in the reinforced concrete, is

More Questions from Structural Design Specifications

• The effective and actual lengths of a cantilever are same if continuous at the support,
• For design of a column the eccentricity of loading shall be taken as the distance from the assumed point of application of the load to the centroid of the column, subject to a minimum of
• The gap between web plates and flange plates for fillet welds should not be more than
• Dispersion of load through the flange to web is considered as dispersed uniformly at an angle θ° is
• If the ratio of effective span to overall depth of a simply supported beam is equal or greater than 1 but less than or equal to 2, the lever arm, is
• In the formula a + bk for the calculation of the net effective section of single angles in tension connected by one leg only, the value of k, is
• If the slenderness ratio of a column is more than 160, the compressive stress obtained by the secant formula is multiplied by a factor in which value of x is
• The distance between, rivet line and the nearest edge of a joint not exposed to weather, is taken (where t is thickness in mm of the thinner outside plate).
• The minimum compressive strength on 15 cm cubes of M 30 grade concrete at 7 days, should be a minimum of
• If D is the overall thickness of the slab, the diameter of the reinforcing bars should not exceed

Discussion & Comments