Curioustab

Home » Civil Engineering » Structural Design Specifications

The designed transverse shear in lacing is assumed as

2.5% of axial load
3% of axial load
3.5% of axial load
4% of axial load.

Correct Answer: 2.5% of axial load

← Previous Question Next Question→

More Questions from Structural Design Specifications

The approximate value of torsion constant k for a box of depth d, width b, and having uniform thickness t, is
A continuous beam shall be deemed to be a deep beam if the ratio of its effective span to overall depth, is
Pick up the correct precaution while spilicing the reinforcing bars
For the plain reinforcing bars in compression, the permissible design bond stress in tension, is increased by
If the dimensions of a rectangular section of a short column are 15 cm x 20 cm, its unsupported length should be restricted to
For rolled I-beams and channels, permissible tensile and compressive stresses does not exceed
For the reinforced concrete member totally immersed in sea water, the normal cover provided for the reinforcing bars is further increased by
The test strength of the sample is taken as the average of the strength of
The reduced level of third floor of a building near a column is 205.350 m. The reduced levels of the undersides of four beams supporting the fourth floor framing into the column mutually perpendicular are 208.350 m, 208.450 m, 208.500 m and 208.550 m. The supported length of the column is
Pick up the correct statement from the following:

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion