Curioustab

Home » Civil Engineering » Structural Design Specifications

For design of a column the eccentricity of loading shall be taken as the distance from the assumed point of application of the load to the centroid of the column, subject to a minimum of

10 mm
20 mm
30 mm
40 mm
50 mm

Correct Answer: 50 mm

← Previous Question Next Question→

More Questions from Structural Design Specifications

The gap between web plates and flange plates for fillet welds should not be more than
Dispersion of load through the flange to web is considered as dispersed uniformly at an angle θ° is
If the ratio of effective span to overall depth of a simply supported beam is equal or greater than 1 but less than or equal to 2, the lever arm, is
In the formula a + bk for the calculation of the net effective section of single angles in tension connected by one leg only, the value of k, is
If the slenderness ratio of a column is more than 160, the compressive stress obtained by the secant formula is multiplied by a factor in which value of x is
The distance between, rivet line and the nearest edge of a joint not exposed to weather, is taken (where t is thickness in mm of the thinner outside plate).
The minimum compressive strength on 15 cm cubes of M 30 grade concrete at 7 days, should be a minimum of
If D is the overall thickness of the slab, the diameter of the reinforcing bars should not exceed
The minimum pitch i.e., the distance between centres of rivet holes is not less than
The value of fbct in the formula for calculating the thickness of a Rectangular base, according to IS : 800-1982, is

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion