Curioustab

Home » Civil Engineering » Strength of Materials

In a beam, the neutral plane

may be its centre
passes through the C.G. of the area of cross-section
does not change during deformation
none of these.

Correct Answer: does not change during deformation

← Previous Question Next Question→

More Questions from Strength of Materials

Struts are load carrying members of a frame structure which are subjected to
The tensile force required to cause an elongation of 0.045 mm in a steel rod of 1000 mm length and 12 mm diameter, is (where E = 2 x 106 kg/cm2)
The phenomenon of slow extension of materials having constant load, i.e. increasing with the time is called
The law which states, "within elastic limits strain produced is proportional to the stress producing it", is known as
If a member carries a tensile force P on its area of cross-section A, the normal stress introduced on an inclined plane making an angle θ with its transverse plane, is
The reaction at the supports will be vertical to the plane of the support if the frame structure rests on
A simply supported wooden beam 150 cm long and having a cross section 16 cm x 24 cm carries a concentrated load, at the centre. If the permissible stress ft = 75 kg/cm2 and fs = 10 kg/cm2 the safe load is
Stress in members of statically determinate simple frames, can be determined by
The nature of the stress in horizontal members of the truss shown in below figure may be
If the normal cross-section A of a member is subjected to tensile force P, the resulting normal stress in an oblique plane inclined at angle θ to transverse plane will be

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion