Curioustab

Home » Civil Engineering » Strength of Materials

Stress in members of statically determinate simple frames, can be determined by

method of joints
method of sections
graphical solution
all the above.

Correct Answer: all the above.

← Previous Question Next Question→

More Questions from Strength of Materials

The nature of the stress in horizontal members of the truss shown in below figure may be
If the normal cross-section A of a member is subjected to tensile force P, the resulting normal stress in an oblique plane inclined at angle θ to transverse plane will be
In a bar of large length when held vertically and subjected to a load at its lower end, its own-weight produces additional stress. The maximum stress will be
A cylinder is said to be thin if the ratio of its thickness and diameter, is less than
Stress in a beam due to simple bending, is
A cantilever beam rectangular in cross-section is subjected to an isolated load at its free end. If the width of the beam is doubled, the deflection of the free end will be changed in the ratio of
A simply supported beam (l + 2a) with equal overhangs (a) carries a uniformly distributed load over the whole length, the B.M. changes sign if
A cantilever carrying a uniformly distributed load W over its full length is propped at its free end such that it is at the level of the fixed end. The bending moment will be zero at its free end also at
A solid cube is subjected to equal normal forces on all its faces. The volumetric strain will be x-times the linear strain in any of the three axes when
If a constant section beam is subjected to a uniform bending moment throughout, its length bends to

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion