Curioustab

Home » Civil Engineering » Strength of Materials

The tensile force required to cause an elongation of 0.045 mm in a steel rod of 1000 mm length and 12 mm diameter, is (where E = 2 x 106 kg/cm2)

166 kg
102 kg
204 kg
74 kg

Correct Answer: 102 kg

← Previous Question Next Question→

More Questions from Strength of Materials

The phenomenon of slow extension of materials having constant load, i.e. increasing with the time is called
The law which states, "within elastic limits strain produced is proportional to the stress producing it", is known as
If a member carries a tensile force P on its area of cross-section A, the normal stress introduced on an inclined plane making an angle θ with its transverse plane, is
The reaction at the supports will be vertical to the plane of the support if the frame structure rests on
A simply supported wooden beam 150 cm long and having a cross section 16 cm x 24 cm carries a concentrated load, at the centre. If the permissible stress ft = 75 kg/cm2 and fs = 10 kg/cm2 the safe load is
Stress in members of statically determinate simple frames, can be determined by
The nature of the stress in horizontal members of the truss shown in below figure may be
If the normal cross-section A of a member is subjected to tensile force P, the resulting normal stress in an oblique plane inclined at angle θ to transverse plane will be
In a bar of large length when held vertically and subjected to a load at its lower end, its own-weight produces additional stress. The maximum stress will be
A cylinder is said to be thin if the ratio of its thickness and diameter, is less than

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion