Curioustab

Home » Civil Engineering » Steel Structure Design

If W and L are the total superimposed load and the span of a plate girder in metres, the approximate self weight (W) of the girder, is taken as

Correct Answer:

← Previous Question Next Question→

More Questions from Steel Structure Design

In case horizontal stiffeners are not used, the distance between vertical legs of flange angles at the top and bottom of a plate girder, is known as
A fillet weld whose axis is parallel to the direction of the applied load, is known as
Effective length of a column effectively held in position and restrained in direction at both ends, is
A riveted joint may experience
Perforated cover plates are particularly suitable for built up sections consisting of
The allowable stress in axial tension is generally kept less if thickness of the member is more than
Effective length of a column effectively held in position and restrained in direction at one end but neither held in position nor restrained in direction at the other end, is
The ratio of the span L of the filler joists to the depth d from the under side of the joist to the top of the structural concrete, should not exceed
If d is the distance between the flange angles, the vertical stiffeners in plate girders without horizontal stiffeners, are spaced at a distance not less than
Assuming the values of maximum deviation ΔP and ΔE to be 25% of the computed value of P and E respectively, the minimum value of the factor of safety is

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion