Curioustab

Home » Civil Engineering » Steel Structure Design

A riveted joint may experience

shear failure
shear failure of plates
bearing failure
bearing failure of rivets
all the above.

Correct Answer: all the above.

← Previous Question Next Question→

More Questions from Steel Structure Design

Perforated cover plates are particularly suitable for built up sections consisting of
The allowable stress in axial tension is generally kept less if thickness of the member is more than
Effective length of a column effectively held in position and restrained in direction at one end but neither held in position nor restrained in direction at the other end, is
The ratio of the span L of the filler joists to the depth d from the under side of the joist to the top of the structural concrete, should not exceed
If d is the distance between the flange angles, the vertical stiffeners in plate girders without horizontal stiffeners, are spaced at a distance not less than
Assuming the values of maximum deviation ΔP and ΔE to be 25% of the computed value of P and E respectively, the minimum value of the factor of safety is
The tensile strength of mild steel for bolts and nuts should not be less than
The maximum tensile and compressive bending stress in extreme fibres of rolled I-sections and channels on the effective section, is
Allowable working stress corresponding to the slenderness ratio of double angles placed back to back and connected to one side of a gusset plate, is reduced to
On eccentrically loaded columns, the equivalent axial load may be obtained by

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion