Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Civil Engineering
»
Steel Structure Design
Assuming the values of maximum deviation ΔP and ΔE to be 25% of the computed value of P and E respectively, the minimum value of the factor of safety is
1.00
0.67
1.67
2.67
none of these.
Correct Answer:
1.67
← Previous Question
Next Question→
More Questions from
Steel Structure Design
The tensile strength of mild steel for bolts and nuts should not be less than
The maximum tensile and compressive bending stress in extreme fibres of rolled I-sections and channels on the effective section, is
Allowable working stress corresponding to the slenderness ratio of double angles placed back to back and connected to one side of a gusset plate, is reduced to
On eccentrically loaded columns, the equivalent axial load may be obtained by
If a pair of angles placed back to back in tension are connected by one leg of each angle, the net effective area of the section, is
The effective length of a double angle strut with angles placed back to back and connected to both the sides of a gusset plate, by not less than two rivets, is
Number of rivets required in a joint, is
The value of f.o.s 'm' in the formula for safe compressive stress for a column is taken as
The diameter of a bolt hole is taken as the nominal diameter of the bolt plus
For a cantilever beam of length L built-in at the support and restrained against torsion at the free end, the effective projecting length l is
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments