Curioustab

Home » Civil Engineering » GATE Exam Questions

The percentage error in the computed discharge over a triangular notch corresponding to an error of 1% in the measurement of the head over the notch, would be

1.0
1.5
2.0
2.5

Correct Answer: 2.5

← Previous Question Next Question→

More Questions from GATE Exam Questions

A hydraulic turbine develops a power of 104 metric horse power while running at a speed of 100 revolutions per minute, under a head of 40 m. Its specific speed is nearest to one of the following :
A 40° slope is excavated to a depth of 10 m in a deep layer of saturated clay of unit weight 20 kN.m3; the relevant shear strength parameters are cu = 70 kN/m2 and φu = 0. The rock ledge is at a great depth. The Taylor's stability coefficient for φu = 0 and 40° slope angle is 0.18. The factor of safety of the slope is :
In a compaction test, as the compaction effort is increased, the optimum moisture content
The number of simultaneous equations to be solved in the slope deflection method, is equal to :
The cylinder strength of the concrete is less than the cube strength because of
In a steady radial flow into an intake, the velocity is found to vary as (1/r2), where r is the radial distance. The acceleration of the flow is proportional to
Principle involved in the relationship between submerged unit weight and saturated weight of a soil is based on
The drop manholes are provided in a sewerage system when there is
Sewage treatment in an oxidation pond is accomplished primarily by :
The following characteristics pertain to the sand filters used in water industry. Filtration rate is 1 to 4 m3 (m2 day). Typical duration of operation in one run is 24 to 72 hours. Operating cost is low. Which of the above characteristics pertain to slow sand filters?

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion