Vertical storage vessels are never supported by __________ support.

More Questions from Process Equipment and Plant Design

• Power required for agitation depends upon the
• Wind load consideration in the design of a support can be neglected, when the vessel is
• Log mean temperature difference in case of multi-pass shell and tube heat exchanger is always
• Practical dividing line between a ductile and brittle materials is suggested, when the ultimate elongation is about 5%. Generally, larger the knuckle radius, stronger is the corner torus section of a head. The knuckle radius provided should be less than __________ of the head.
• The ratio of lateral strain to linear strain is termed as the
• Frame thickness in the plate and frame filter press is normally in the range of __________ inches.
• In a shell and tube heat exchanger having square pitch, the shell side equivalent diameter is given by (where, P = pitch, d = outside diameter of the tube)
• Filtration rate is affected by the
• __________ heat exchanger is also known as 'hair pin type' exchanger,
• Optimum economic pipe diameter for fluid flow is determined by the

Discussion & Comments