Curioustab

Home » Chemical Engineering » Process Equipment and Plant Design

Log mean temperature difference in case of multi-pass shell and tube heat exchanger is always

less than arithmetic mean value.
more than arithmetic mean value.
more than geometric mean value.
both(b) & (c).

Correct Answer: less than arithmetic mean value.

← Previous Question Next Question→

More Questions from Process Equipment and Plant Design

Practical dividing line between a ductile and brittle materials is suggested, when the ultimate elongation is about 5%. Generally, larger the knuckle radius, stronger is the corner torus section of a head. The knuckle radius provided should be less than __________ of the head.
The ratio of lateral strain to linear strain is termed as the
Frame thickness in the plate and frame filter press is normally in the range of __________ inches.
In a shell and tube heat exchanger having square pitch, the shell side equivalent diameter is given by (where, P = pitch, d = outside diameter of the tube)
Filtration rate is affected by the
__________ heat exchanger is also known as 'hair pin type' exchanger,
Optimum economic pipe diameter for fluid flow is determined by the
Pick out the wrong statement pertaining to shell and tube heat exchanger.
Tube height in a calendria type evaporator is normally less than __________ metres.
A shell may by termed as thin if its thickness to diameter ratio is less than 0.1. The factor which can be neglected in the calculation of membrane stresses is

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion