Curioustab

Home » Chemical Engineering » Process Equipment and Plant Design

The distance between the centre of a rivet hole to the nearest edge of the plate is called

pitch
margin
back pitch
none of these

Correct Answer: margin

← Previous Question Next Question→

More Questions from Process Equipment and Plant Design

Vertical storage vessels are never supported by __________ support.
Power required for agitation depends upon the
Wind load consideration in the design of a support can be neglected, when the vessel is
Log mean temperature difference in case of multi-pass shell and tube heat exchanger is always
Practical dividing line between a ductile and brittle materials is suggested, when the ultimate elongation is about 5%. Generally, larger the knuckle radius, stronger is the corner torus section of a head. The knuckle radius provided should be less than __________ of the head.
The ratio of lateral strain to linear strain is termed as the
Frame thickness in the plate and frame filter press is normally in the range of __________ inches.
In a shell and tube heat exchanger having square pitch, the shell side equivalent diameter is given by (where, P = pitch, d = outside diameter of the tube)
Filtration rate is affected by the
__________ heat exchanger is also known as 'hair pin type' exchanger,

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion