Curioustab

Home » Chemical Engineering » Process Equipment and Plant Design

Frame thickness in the plate and frame filter press is normally in the range of __________ inches.

0.25 to 4
0.25 to 8
1 to 5
1 to 12

Correct Answer: 0.25 to 8

← Previous Question Next Question→

More Questions from Process Equipment and Plant Design

In a shell and tube heat exchanger having square pitch, the shell side equivalent diameter is given by (where, P = pitch, d = outside diameter of the tube)
Filtration rate is affected by the
__________ heat exchanger is also known as 'hair pin type' exchanger,
Optimum economic pipe diameter for fluid flow is determined by the
Pick out the wrong statement pertaining to shell and tube heat exchanger.
Tube height in a calendria type evaporator is normally less than __________ metres.
A shell may by termed as thin if its thickness to diameter ratio is less than 0.1. The factor which can be neglected in the calculation of membrane stresses is
Steam economy is defined as the amount of evaporation per unit amount of steam used, while the capacity is the total evaporation obtained per hour. Use of multiple effect in evaporation
Souders Brown equation given by, , is used for the calculation of the __________ in a continuous distillation column.
What is the slope of the feed line, if the feed to a distillation column is a saturated liquid?

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion