In a shell and tube heat exchanger having triangular pitch, the shell side equivalent diameter is given by

More Questions from Process Equipment and Plant Design

• A high vapour velocity is required for high plate efficiency in a seive plate coloumn. The satisfactory value of operating vapor velocity for design purpose in seive plate column is about __________ percent of the flooding velocity.
• Welded joint efficiency in the design of chemical process equipment is taken as
• Overall mass transfer co-efficient in case of absorption of __________ in water is based on the gas film co-efficient only, as the mass transfer process is gas film (phase) controlling.
• The equivalent diameter for pressure drop is __________ that for heat transfer.
• Most of the storage vessels/tanks are made cylindrical, because of the fact that a cylinder
• Safety valves are provided in chemical equipments to guard against excessive
• Pick out the correct statement
• For identical situation, condensing film coefficient in case of a horizontal condenser is almost __________ the value expected in case of vertical condenser.
• A single pass air heater is connected to a two pass unit. For the air flow rate and other conditions remaining the same, the film heat transfer co-efficient for air will vary in the ratio of
• The thickness of segmental baffles (25 -35% cut truncated plates usually) is generally __________ the tube wall thickness.

Discussion & Comments