Curioustab

Home » Chemical Engineering » Process Equipment and Plant Design

Most of the storage vessels/tanks are made cylindrical, because of the fact that a cylinder

has greater structural strength.
is easy to fabricate.
both (a) and (b).
neither (a) nor (b).

Correct Answer: both (a) and (b).

← Previous Question Next Question→

More Questions from Process Equipment and Plant Design

Safety valves are provided in chemical equipments to guard against excessive
Pick out the correct statement
For identical situation, condensing film coefficient in case of a horizontal condenser is almost __________ the value expected in case of vertical condenser.
A single pass air heater is connected to a two pass unit. For the air flow rate and other conditions remaining the same, the film heat transfer co-efficient for air will vary in the ratio of
The thickness of segmental baffles (25 -35% cut truncated plates usually) is generally __________ the tube wall thickness.
In a multipass shell and tube heat exchanger, the baffles on shell side is primarily provided for
Mc Cable Thiele method used for finding theoretical stages in a distillation column assumes that the
What is the value of 'q' for saturated vapor feed to a distillation column?(where q = fraction of the feed stream that is liquid.)
for 90° elbow (medium radius) and 90°square elbow would be respectively around
For a 25 mm hole drilled in plates to be rivetted, the shank diameter of the rivet should be __________ mm.

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion