Curioustab

Home » Chemical Engineering » Process Equipment and Plant Design

Safety valves are provided in chemical equipments to guard against excessive

temperature
pressure/pressure fluctuation
turbulence
noise

Correct Answer: pressure/pressure fluctuation

← Previous Question Next Question→

More Questions from Process Equipment and Plant Design

Pick out the correct statement
For identical situation, condensing film coefficient in case of a horizontal condenser is almost __________ the value expected in case of vertical condenser.
A single pass air heater is connected to a two pass unit. For the air flow rate and other conditions remaining the same, the film heat transfer co-efficient for air will vary in the ratio of
The thickness of segmental baffles (25 -35% cut truncated plates usually) is generally __________ the tube wall thickness.
In a multipass shell and tube heat exchanger, the baffles on shell side is primarily provided for
Mc Cable Thiele method used for finding theoretical stages in a distillation column assumes that the
What is the value of 'q' for saturated vapor feed to a distillation column?(where q = fraction of the feed stream that is liquid.)
for 90° elbow (medium radius) and 90°square elbow would be respectively around
For a 25 mm hole drilled in plates to be rivetted, the shank diameter of the rivet should be __________ mm.
In a shell and tube heat exchanger for a given heat transfer surface area, smaller diameter tubes are favoured as compared to larger diameter ones ; because the smaller diameter tubes

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion