Curioustab

Home » Chemical Engineering » Process Equipment and Plant Design

For identical situation, condensing film coefficient in case of a horizontal condenser is almost __________ the value expected in case of vertical condenser.

half
twice
thrice
five times

Correct Answer: thrice

← Previous Question Next Question→

More Questions from Process Equipment and Plant Design

A single pass air heater is connected to a two pass unit. For the air flow rate and other conditions remaining the same, the film heat transfer co-efficient for air will vary in the ratio of
The thickness of segmental baffles (25 -35% cut truncated plates usually) is generally __________ the tube wall thickness.
In a multipass shell and tube heat exchanger, the baffles on shell side is primarily provided for
Mc Cable Thiele method used for finding theoretical stages in a distillation column assumes that the
What is the value of 'q' for saturated vapor feed to a distillation column?(where q = fraction of the feed stream that is liquid.)
for 90° elbow (medium radius) and 90°square elbow would be respectively around
For a 25 mm hole drilled in plates to be rivetted, the shank diameter of the rivet should be __________ mm.
In a shell and tube heat exchanger for a given heat transfer surface area, smaller diameter tubes are favoured as compared to larger diameter ones ; because the smaller diameter tubes
__________ closure is the weakest enclosure for cylindrical vessels.
In hydrostatic testing of welded pipe (for leakage, strength etc.) the ratio of minimum hydrostatic test pressure to internal design pressure is around

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion