Curioustab

Home » Chemical Engineering » Process Equipment and Plant Design

A high vapour velocity is required for high plate efficiency in a seive plate coloumn. The satisfactory value of operating vapor velocity for design purpose in seive plate column is about __________ percent of the flooding velocity.

45
60
80
95

Correct Answer: 80

← Previous Question Next Question→

More Questions from Process Equipment and Plant Design

Welded joint efficiency in the design of chemical process equipment is taken as
Overall mass transfer co-efficient in case of absorption of __________ in water is based on the gas film co-efficient only, as the mass transfer process is gas film (phase) controlling.
The equivalent diameter for pressure drop is __________ that for heat transfer.
Most of the storage vessels/tanks are made cylindrical, because of the fact that a cylinder
Safety valves are provided in chemical equipments to guard against excessive
Pick out the correct statement
For identical situation, condensing film coefficient in case of a horizontal condenser is almost __________ the value expected in case of vertical condenser.
A single pass air heater is connected to a two pass unit. For the air flow rate and other conditions remaining the same, the film heat transfer co-efficient for air will vary in the ratio of
The thickness of segmental baffles (25 -35% cut truncated plates usually) is generally __________ the tube wall thickness.
In a multipass shell and tube heat exchanger, the baffles on shell side is primarily provided for

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion