Curioustab

Home » Certification » CISCO Certification

If you wanted administrators to see a message when logging into the router, which command would you use?

message banner motd
banner message motd
banner motd
message motd

Correct Answer: banner motd

Explanation:

The typical banner is a message of the day (MOTD) and is set by using the global configuration mode command banner motd.

← Previous Question Next Question→

More Questions from CISCO Certification

What command do you type to save the configuration stored in RAM to NVRAM?
Which command will show you whether a DTE or a DCE cable is plugged into serial 0?
If you delete the contents of NVRAM and reboot the router , what mode will you be in?
Which of the following commands will configure all the default VTY ports on a router?
Which of the following commands sets the secret password to Cisco?
You type Router#sh ru and receive a % ambiguous command error. why did you receive this message?
At which layer of the OSI model would you assume the problem is if you type show interface serial 1 and receive the following message? Serial 1 is down, line protocol is down
Which commands loads a new version of the Cisco IOS into a router?
You copy a configuration from a network host to a router's RAM. The configuration looks correct, yet it is not working at all. What could the problem be?
The corporate office sends you a new router to connect, but upon connecting the console cable, you see that there is already a configuration on the router. What should be done before a new configuration is entered in the router?

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion