Home » Certification » CISCO Certification

You copy a configuration from a network host to a router's RAM. The configuration looks correct, yet it is not working at all. What could the problem be?

You copied the wrong configuraion into RAM
You copied the configuration into flash memory instead
The copy did not override the shutdown command in running-config
The IOS became corrupted after the copy command was initiated

Correct Answer: The copy did not override the shutdown command in running-config

Explanation:

Since the configuration looks correct, you probably didn't screw up the copy job. However , when you perform a copy from a network host to a router , the interfaces are automatically shut dow and need to be manually enabled with the no shutdown command.

← Previous Question Next Question→

More Questions from CISCO Certification

The corporate office sends you a new router to connect, but upon connecting the console cable, you see that there is already a configuration on the router. What should be done before a new configuration is entered in the router?
You are troubleshooting a connectivity problem in your corporate network and want to isolate the problem. You suspect that a router on the route to an unreachable network is at fault. What IOS user exec command should you issue?
You need to gather the IP address of a remote switch that is located in Hawaii. What can you do to find the address?
If you want to have more than one Telnet session open at the same time, what keystroke combination would you use?
What is the command to copy a Cisco IOS to a TFTP server?
Which of the following is the best description of the operation of split horizon?
Which command displays RIP routing updates?
What metric does RIPv2 use to find the best path to a remote network?
Two connected routers are configured only with RIP routing. What will be the result when a router receives a routing update that contains a higher-cost path to a network already in its routing table?
When a PC sends a packet to another PC in a remote network, what destination IP address and MAC address will be in the frame that it sends to its default gateway?

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion