Home » Certification » CISCO Certification

If you delete the contents of NVRAM and reboot the router , what mode will you be in?

privileged mode
Global mode
Setup mode
NVRAM loaded mode

Correct Answer: Setup mode

Explanation:

If you delete the startup-config and reload the router, the router will automatically enter setup mode. You can also type setup from privileged mode at any time.

← Previous Question Next Question→

More Questions from CISCO Certification

Which of the following commands will configure all the default VTY ports on a router?
Which of the following commands sets the secret password to Cisco?
You type Router#sh ru and receive a % ambiguous command error. why did you receive this message?
At which layer of the OSI model would you assume the problem is if you type show interface serial 1 and receive the following message? Serial 1 is down, line protocol is down
Which commands loads a new version of the Cisco IOS into a router?
You copy a configuration from a network host to a router's RAM. The configuration looks correct, yet it is not working at all. What could the problem be?
The corporate office sends you a new router to connect, but upon connecting the console cable, you see that there is already a configuration on the router. What should be done before a new configuration is entered in the router?
You are troubleshooting a connectivity problem in your corporate network and want to isolate the problem. You suspect that a router on the route to an unreachable network is at fault. What IOS user exec command should you issue?
You need to gather the IP address of a remote switch that is located in Hawaii. What can you do to find the address?
If you want to have more than one Telnet session open at the same time, what keystroke combination would you use?

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion