Curioustab

Home » Certification » CISCO Certification

Which commands loads a new version of the Cisco IOS into a router?

copy flash ftp
copy ftp flash
copy flash tftp
copy tftp flash

Correct Answer: copy tftp flash

Explanation:

The command copy tftp flash will allow you to copy a new IOS into flash memory on your router.

← Previous Question Next Question→

More Questions from CISCO Certification

You copy a configuration from a network host to a router's RAM. The configuration looks correct, yet it is not working at all. What could the problem be?
The corporate office sends you a new router to connect, but upon connecting the console cable, you see that there is already a configuration on the router. What should be done before a new configuration is entered in the router?
You are troubleshooting a connectivity problem in your corporate network and want to isolate the problem. You suspect that a router on the route to an unreachable network is at fault. What IOS user exec command should you issue?
You need to gather the IP address of a remote switch that is located in Hawaii. What can you do to find the address?
If you want to have more than one Telnet session open at the same time, what keystroke combination would you use?
What is the command to copy a Cisco IOS to a TFTP server?
Which of the following is the best description of the operation of split horizon?
Which command displays RIP routing updates?
What metric does RIPv2 use to find the best path to a remote network?
Two connected routers are configured only with RIP routing. What will be the result when a router receives a routing update that contains a higher-cost path to a network already in its routing table?

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion