Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Biochemical Engineering
»
Agitation and Aeration
Turbine impeller consists of flat impeller blades with
a vertical pitch welded directly to the shaft
a angled pitch welded directly to the shaft
a vertical pitch welded to a horizontal disk
a angled pitch welded to a horizontal disk
Correct Answer:
a vertical pitch welded to a horizontal disk
← Previous Question
Next Question→
More Questions from
Agitation and Aeration
The power consumption in a stirring vessel can be assessed by using a
The rate limiting step in the movement of oxygen from the gas phase in a bubble to the cell is the movement of oxygen molecules through
Swirling and vortex formation can be prevented by
Gas hold up, characterizing the hydrodynamics in a fermenter, mainly depends on the
When liquid is pumped through cooling coil in a stirred tank reactor to cool. Which of the following is not correct?
If liquid density and viscosity remains constant, then the Reynolds number in a stirred tank reactor will vary with the
The oxygen uptake requirements of a microbial population is characterized by the following parameters: μm = 0.2 h-1, K0 = 0.2 mg O2.l-1, Y0 = 0.5 mg dry weight/mg O2 and C0,crit=0.8 mg.l-1 The required concentration of cells is 1000 mg.l-1 and the saturation oxygen concentration of the medium is 5.8 mg.l-1. The required KLa must be greater than
Radial flow impellers
What is the ratio of diameter of impeller to the diameter of tank (Da:Dt)?
The volume of liquid (VL) in a cylindrical reactor can be calculated from the liquid height (HL) and tank diameter (Dt) using the following equation
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments