Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Biochemical Engineering
»
Agitation and Aeration
The power consumption in a stirring vessel can be assessed by using a
dynamometer
strain gauge attached to agitator shaft
watt meter attached to agitator motor
all of these
Correct Answer:
all of these
← Previous Question
Next Question→
More Questions from
Agitation and Aeration
The rate limiting step in the movement of oxygen from the gas phase in a bubble to the cell is the movement of oxygen molecules through
Swirling and vortex formation can be prevented by
Gas hold up, characterizing the hydrodynamics in a fermenter, mainly depends on the
When liquid is pumped through cooling coil in a stirred tank reactor to cool. Which of the following is not correct?
If liquid density and viscosity remains constant, then the Reynolds number in a stirred tank reactor will vary with the
The oxygen uptake requirements of a microbial population is characterized by the following parameters: μm = 0.2 h-1, K0 = 0.2 mg O2.l-1, Y0 = 0.5 mg dry weight/mg O2 and C0,crit=0.8 mg.l-1 The required concentration of cells is 1000 mg.l-1 and the saturation oxygen concentration of the medium is 5.8 mg.l-1. The required KLa must be greater than
Radial flow impellers
What is the ratio of diameter of impeller to the diameter of tank (Da:Dt)?
The volume of liquid (VL) in a cylindrical reactor can be calculated from the liquid height (HL) and tank diameter (Dt) using the following equation
Which of the following impellers are used for wide range of viscosities?
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments