Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Technical Drawing
»
Tolerancing
This is the term for the range of tightness or looseness resulting from the allowances and tolerances in mating parts:
Limits
Fit
Specifications
Allowance
Correct Answer:
Fit
← Previous Question
Next Question→
More Questions from
Tolerancing
This means that a feature of a finished product contains the maximum amount of material permitted by the toleranced dimensions for that feature:
This is the theoretically exact size from which limits of size are determined:
Acceptable parts must not extend beyond this:
When lines intersect on a drawing at angles of this many degrees, it is customary not to dimension the angle:
Unilateral tolerances have traditionally been given on angles.
Allowance is the maximum clearance or minimum interference specified to achieve a fit between two mating parts.
Implied 90 degree angles typically have different general tolerances applied to them than other angles covered by a general note.
Nominal size is used for general identification and is usually expressed in decimals.
Tolerances of form and position are typically not used to control straightness.
Defining the datum reference frame is necessary to apply GDT principles.
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments