Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Technical Drawing
»
Isometric Drawings
Architectural drafters generally prefer to use ________ drawings to help illustrate 3-dimensional views of a structure.
isometric
perspective
orthographic
auxiliary
Correct Answer:
perspective
Next Question→
More Questions from
Isometric Drawings
The Offset tool should only be used for placing ________ in an isometric drawing.
A round is a rounded surface on the ________ corner of a part.
AutoCAD refers to isometric ellipses as ________.
Isometric drawings are often used by ________ to help illustrate complex designs.
In order to create an isometric circle to represent a hole through the top surface of a box, the drafter must insure that the correct isoplane has been selected by scrolling through the isoplanes using the ________ key.
The bounding box method for setting up an isometric drawing helps the drafter ________.
When creating an isometric drawing in AutoCAD the drafter can utilize the Dynamic Input and Polar Coordinate system to place both vertical and horizontal lines. A line created from one point 3 inches at 180 degrees would be a ________ line.
A fillet is a rounded surface on the ________ corner of a part.
Before starting an isometric drawing in AutoCAD the drafter needs to ________.
The Offset command can be used on vertical lines but not on horizontal lines.
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments