Curioustab

Home » Technical Drawing » Auxiliary Views

This type of surface may be a plane, a single curved surface, or a warped surface:

Edge surface
Ruled surface
Auxiliary surface
Developed surface

Correct Answer: Ruled surface

← Previous Question Next Question→

More Questions from Auxiliary Views

A partial auxiliary view is used to show only the ________ in the auxiliary view.
This is the most common application for developments and intersections:
This type of auxiliary view is projected onto a plane that is perpendicular to one of the principal planes of projection:
The principle views associated with orthographic projection are ________.
In this type of view, the cutting plane line indicates both the location of the cutting plane and the direction of sight:
An efficient method for trimming the corners on an auxiliary view is to use the ________.
A partial auxiliary view usually shows only features on the ________ of the inclined line and not any projection of other planes.
The lines used to create the auxiliary view should appear as ________ in the finished view.
The offset distance for the width (front to back) distance of the auxiliary view is the same distance of the ________ in the top view.
When using the descriptive geometry method to create an auxiliary view the drafter should ________.

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion