Curioustab

Home » Digital Electronics » Counters

A sequential circuit design is used to ________.

count up
count down
decode an end count
count in a random order

Correct Answer: count in a random order

← Previous Question Next Question→

More Questions from Counters

________ is the output frequency of the counter shown below.
One method of troubleshooting involves ________ the circuit under test with a ________ or ________ and then observing the output to check for proper bit patterns.
The given circuit represents a(n) ________.
Many parallel counters use ________ presetting whereby the counter is preset on the active transition of the same clock signal that is used for counting.
The technique used by one-shots to respond to an edge rather than a level is called ________.
Assume you want to determine the timing diagram for a 4-bit counter using an oscilloscope. The best choice for an oscilloscope trigger signal is ________.
Asynchronous counters are often called ________ counters.
Assume a 4-bit ripple counter has a failure in the second flip-flop such that it "locks up." The third and fourth stages will ________.
A reliable method for eliminating decoder spikes is the technique called ________.
A glitch that appears on the decoded output of a ripple counter is often difficult to see on an oscilloscope because ________.

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion