When setting up Frame Relay for point-to-point subinterfaces, which of the following must not be configured?

The Frame Relay encapsulation on the physical interface
The local DLCI on each subinterface
An IP address on the physical interface
The subinterface type as point-to-point

Correct Answer: An IP address on the physical interface

Explanation:

It is very important to remember when studying the CCNA exam objectives, and when configuring Frame Relay with point-to-point subinterfaces, that you do not put an IP address on the physical interface.

← Previous Question Next Question→

More Questions from Wide Area Networks

Which of the following describes an industry-wide standard suite of protocols and algorithms that allows for secure data transmission over an IP-based network that functions at the layer 3 Network layer of the OSI model?
Which of the following describes the creation of private networks across the Internet, enabling privacy and tunneling of non-TCP/IP protocols?
You need to configure a router for a Frame Relay connection to a non-Cisco router. Which of the following commands will prepare the WAN interface of the router for this connection?
Which of the following encapsulates PPP frames in Ethernet frames and uses common PPP features like authentication, encryption, and compression?
Which of the following uses ATM as the Data Link layer protocol that's terminated at what's known as the DSLAM?
Which command is required for connectivity in a Frame Relay network if Inverse ARP is not operational?
When a router is connected to a Frame Relay WAN link using a serial DTE interface, how is the clock rate determined?
Which command will display the CHAP authentication process as it occurs between two routers in the network?
How should a router that is being used in a Frame Relay network be configured to keep split horizon issues from preventing routing updates?
Which of the following command options are displayed when you use the Router# show frame-relay? command? dlci neighbors lmi pvc map

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion